Steps
1. Slide the back I/O-ports on the system board into the front I/O-slots on the chassis and align the screw holes on the system board
with the screw holes on the chassis.
2. Replace the screw (M2x4) that secures the system board to the chassis.
3. Install the
VR heat
sink.
NOTE:
The VR heat sink is shipped as a separate unit and it does not ship along with the system board. Ensure that
you replace the VR heat sink from old system board to the new system board.
4. Replace the eight screws (#6-32) that secure the system board to the chassis.
5. Route and connect all the cables that you disconnected from the system board.
NOTE:
For information on system-board connectors, see
6. Align the front I/O-bracket with the slots on the chassis.
7. Replace the screw (#6-32) that secures the front I/O-bracket to the chassis.
58
Removing and installing components
"System-board
components".