Weber Q 300 Owner's Manual page 18

18
REFILLING THE LPGG CYLINDER
We recommend that you refi ll the LPG cylinder before it is completely empty.
To refi ll, take LPG cylinder to a "Gas Propane" dealer.
Removal of the gas supply cylinder
1) Shut off gas supply.
2) Disconnect hose with regulator from the cylinder.
3) Exchange empty cylinder for a full cylinder.
LIGHTING
Summary lighting instructions are posted on the cart leg under the control
knobs (L).
Failure to open the lid while igniting the barbecue's
burners, or not waiting 5 minutes to allow the gas to
clear if the barbecue does not light, may result in an
explosive fl ame-up which can cause serious bodily
injury or death.
1).
5).
3).
A. - OFF
C. - MED
1) Open the lid.
2) Make sure all burner control knobs are turned OFF. (Push control knob
in and turn clockwise to ensure that it is in the OFF position.)
3) Turn the gas on by slowly turning the cylinder valve counterclockwise.
Wait 60 seconds.
WARNING: Do not lean over the open barbecue when
lighting the barbecue.
4) Select the Outside burner, push control knob in and turn to START/HI.
5) Push the ignition button, so that it clicks. Repeat if necessary
6) Check that the burner is lit by looking down through the cooking grate.
You should see a fl ame.
Gas Instructions Gas Instructions
DANGER
6).
2).
L).
B. - START/ HI
D. - LOW
WARNING: Check hose before each use of barbecue
for nicks, cracking, abrasions or cuts. If the hose
is found to be damaged in any way, do not use the
barbecue. Replace using only Weber
replacement hose. Contact the Customer Service
Representative in your area using the contact
information on our web site. Log onto www.weber.com
Ignition System
Note - The ignition system ignites the burners with a spark from the igniter
electrode inside the ignition chamber. You generate the energy for the spark
by pushing the ignition button until it clicks.
4).
A B
WARNING: If the burner does not light, turn the burner
control knob to OFF and wait 5 minutes to let the gas
clear before you try again or try to light with a match.
7) After the Outside burner is lit you can turn on the Inside burner. The
Inside burner is ignited from the Outside burner.
TO EXTINGUISH
Push in and turn each burner control knob clockwise to the OFF position.
Turn gas supply OFF at the source.
(1)
(2)
®
authorized
C
.
®
D