Roland VersaUV LEF-12 First Step Manual page 40

First Time Printing
 Do not use media that is charged with static electricity.
 This printer cannot print on all materials. When selecting media, be sure to carry out testing in
advance to make sure that satisfactory print quality can be obtained.
 There is a limit to the variation in the unevenness on the print surface. For more information, see
"Height Settings When the Print Surface is Uneven" in the Master Guide.
 Depending on the type of media and the installation method, the height may not be set correctly.
The machine may malfunction if printing is performed under these conditions. Do not use the
following types of media.
Media that easily becomes loose
If media becomes loose, the media gap sen-
sor cannot detect the height correctly. Make
sure you place media so that it does not
become loose. If the media does become
loose, you can use an adhesive sheet to
hold it in place.
Printable area
Maximum printable area: Width 305 mm (12.01 in) x length 280 mm (11.03 in) x height 100 mm (3.94 in)
 The maximum printable area is inside the marking-off line on the flat table.
 The maximum size of the media and the printable area are different.
38
Flat table
(Front)
305 mm
Media made from soft material
If the media is made from soft material, the
pressure applied against the media gap
sensor is too weak. This prevents it from
detecting the height correctly.
Marking-off line
Media
100 mm
Flat table