Roland VersaUV LEF-12 First Step Manual page 37


SUBNET MASK
000 . 000 . 000 . 000

SUBNET MASK
255 . 000 . 000 . 000


Repeat and

SUBNET MASK
255 . 255 . 255 . 000

SETUP MEDIA
If you use the computer and the machine one-on-one basis, this will complete the settings to make on
the printer. Go on to "Make the Port Settings for the Software RIP. "
If you need to set the gateway address, then go on to the procedure following this one.
3.
Set the gateway address

NETWORK
IP ADDRESS

NETWORK
GATEWAY ADDR.

GATEWAY ADDR.
255 . 000 . 000 . 000

GATEWAY ADDR.
255 . 000 . 000 . 000


Repeat and

GATEWAY ADDR.
255 . 255 . 255 . 255

SETUP MEDIA
Make the Port Settings for the Software RIP
 Install the software RIP and set it up. For the print destination, use the IP address set on the printer. For
settings information, refer to the documentation for the software RIP.
 You can check whether the connection to the network has been complete by using the printing-test feature
of the software. For the information on the method to conduct a printing test, refer to the documentation
for the software RIP.
Use
[SUBNET MASK]: 255.255.255.000
Note: For the subnet mask, make the setting the same value as the one used
by the computer. Here, "255.255.255.000" is entered by way of example.
Press

to set the subnet mask.
When you finish making the setting, press
Press
Press
From the screen displayed in
Press
Use
[GATEWAY ADDR.]: 255.255.255.255
For the value to enter for your gateway address, consult your network ad-
ministrator. Here, "255.255.255.255" is entered by way of example.
Press

to set the gateway address numbers.
When you finish making the setting, press
Press
Press
to select the address number.
.
.
to go back to the original screen.
1.-
twice.
to select the address number.
.
.
to go back to the original screen.
Before Using This Printer
.

, press twice.
.
35