Steady Shot Check - Sony DCR-IP45 Service Manual

19. Steady Shot Check

Precautions on the Parts Replacement
There are two types of repair parts.
Type A: ENC03MA
Type B: ENC03MB
Replace the broken sensor with a same type sensor. If replace with
other type parts, the image will vibrate up and down or left and
right during hand-shake correction operations.
Precautions on Angular Velocity Sensor
The sensor incorporates a precision oscillator. Handle it with care
as if it dropped, the balance of the oscillator will be disrupted and
operations will not be performed properly.
Subject Arbitrary
Measurement Point Display data of page 1 (Note1)
Measuring Instrument Adjustment remote commander
Specified Value 2B00 to 4B00
Note1: Displayed data of the adjustment remote commander.
1 : XX : XX
Display data
Note2: The data of page: 0, address: 10 must be "00".
Switch setting:
1) STEADY SHOT (Menu display) ...................................... ON
2) ZOOM .................................................................... TELE end
Adjusting method:
Order Page Address Data
1 0 03 11
2 1
3 0 03 12
4 1
Processing after Completing Adjustments:
Order Page Address Data
1 0 03 00
2
Procedure
Pitch sensor check
(CD-399 board SE3101)
Set the data.
Check that the display data
(Note1) satisfies the specified
value.
Yaw sensor check
(CD-399 board SE3102)
Set the data.
Check that the display data
(Note1) satisfies the specified
value.
Procedure
Set the data.
Move the camcorder, and check
that the steady shot operations
have been performed normally
DCR-IP45/IP45E/IP55/IP55E
5-33