Sentrilock Lockbox NXT Series Getting Started Manual page 7

When you finish, press ENT. Leave your SentriCard® in the lockbox! If you made a mistake keying in the
number, simply repeat this step.
Press FUNC + 3 followed by ENT. The key compartment will open. Place the dwelling
5.
key(s) in the key vault and close the lockbox door. When using Function 3 to open the
key compartment, wait for the green READY light to go solid before closing the key
compartment. This is also true when using a SentriCard® to open the key compartment
during a showing.
6. You may now remove your SentriCard® from the lockbox.
7. Hang the shackle over the door knob (or some other sturdy fixture that will allow the
lockbox to hang vertically),
8. Firmly press the shackle into the lockbox. Make sure you hear the click that indicates the
shackle is completely latched in the lockbox. Do not attach the lockbox to an object that
could fill it with water, and make sure the card slot is the lowest point on the lockbox as it
is also the drain point for any water that gets into the lockbox.
Note: Once the key compartment has been latched closed, the lockbox will enter Hardlock Mode. This mode
provides added security by locking the latches into an immovable state.
4Getting Started
Figure 3 Opening the key compartment of a lockbox
Figure 4 Placing a lockbox on a listing
NXT Series Lockbox Getting Started Guide