Sentrilock GENI Quick Start Manual

Changing the Battery in a GENI/GENII Lockbox

Introduction
The GENI or GENII (silver) REALTOR® lockbox has an internal lithium battery. The batteries in GENI
lockboxes last between 2 to 3 years, depending upon climate, storage and use. The batteries in GENII
lockboxes last up to 6 years, depending upon climate, storage and use.
Note: Do not remove old batteries from a lockbox until you have a replacement in hand. Also, do
not carry unpackaged batteries in your pocket or purse as
metal objects could cause a short circuit and thereby cause
bodily harm or property damage.

What you Will Need

To replace the battery in a GENI or GENII (silver) lockbox, you will
need:
1 lithium type 2CR5 battery. Contact your Association to
obtain a battery for your lockbox.
A 5/64" hex/allen wrench or a T10 torx driver to remove the
battery cover screws.
Note: Use a 5/64" inch hex/allen wrench if the screws look like hexagons. Use a T10 torx
driver if the screws look like stars.
The battery cover for a GENI or GENII (silver) lockbox is easy to identify because it may have a white
label affixed to it. It can be found on the back side of the lockbox.

How to Replace the Battery in a GENI/GENII Lockbox

Follow the instructions below to replace the battery in a GENI or GENII (silver) lockbox:
1. Before replacing the battery, you should lock the keypad if the lockbox is still showing signs of
activity. This will retain the current lockbox timekeeping settings while you are replacing the
battery. If the lockbox is completely dead before replacing the battery, you do not need to lock
the keypad. Insert your SentriCard® into the lockbox. When the lockbox displays the CODE light,
enter your PIN + ENT.
2. On the keypad, press FUNC + 6 + 7 + ENT to lock the keypad.