Logs Tab - Macurco AimSafety PM 100 User Instructions

PM100 Bump Test and Calibration Station

5.3.3 Logs Tab

Logs are stored on the USB Disk and can be viewed on a computer using the Bump-Calibration Station Manager
software. The log files will be formatted as .csv files (comma separated values) for easy viewing and manipulation
with spreadsheet software. A log file will be created for each PM monitor used in the Bump-Calibration Station. A
100
R R
single log file will be created for the Bump-Calibration Station.
NOTE: The Logs tab is not available if connected via USB Disk. Instead, the log files can be viewed and saved directly
by navigating to the "Logs" folder in the USB Disk.
5.3.3.1 View Log Files
To view a list of the log files, click Refresh while connected to the Bump-Calibration Station. The log file names will
appear in the list box and a "Log file receive success" message will pop-up when the list is complete. Log file names
are based on the serial number of the device.
REV – 1.0 [34-2900-0513-2 ] 18 | P a g e