Table of Contents
Advertisement
PM100 Bump Test and Calibration Station
8. When the installation is complete, click Finish to exit the Setup Wizard.
5.2 Connect to the Calibration Station
When the Bump-Calibration Station Manager software is first opened, the fields are grayed out. The software must
be connected to the Bump-Calibration Station before it can be used. There are two methods to connect the
software to the Bump-Calibration Station: A PM Link or the included USB Disk can be used.
5.2.1 Connect Using PM Link
The Bump-Calibration Station can be conveniently configured using the PM Link device. The unit can communicate
with the PM Link device using the IR communication in Unit 1 bay.
To connect using the PM Link,
1. Plug the PM Link device into a USB port on your computer.
2. Place the PM Link device in Unit 1 bay with the IR lens of the PM Link facing the IR lens of the Unit 1 bay.
3. Make sure the Bump-Calibration Station power is on indicated by the green Power LED.
4. Open the Bump-Calibration Station Manager software.
5. Make sure the "IR" option at the top of the software interface is selected.
REV – 1.0
[34-2900-0513-2 ]
11 |
P a g e
Advertisement
Table of Contents
