Table of Contents
Advertisement
PM100 Bump Test and Calibration Station
This field allows you to enter the gas concentration(s) of the test gas cylinder installed in the Bump-Calibration
Station. This is necessary for proper testing and calibration of PM
and O2.
5.3.2.3
PM100 Option Info Read/Write
IMPORTANT: Any changes made to the PM100 tab will not be saved to the Bump-Calibration Station until the
"Write" button is clicked.
To write the data from the PM100 tab to the Bump-Calibration Station, press Write.
To read the current PM
100
R
NOTE: Pressing Read will cause any unsaved changes on the PM100 tab to be lost.
5.3.2.4
PM100 Firmware Upgrade
The Bump-Calibration Station can be used to upgrade the PM
copy of the PM
firmware saved on its USB Disk. PM
100
R
R
monitor's gas type. If there is a new firmware version, the file can be found at https://macurco.com/downloads/.
To update the PM
firmware file,
100
R
R
1. Press Browse to open the file explorer.
2. Navigate to the PM
3. Press Open.
4. Press Write. The PM
REV – 1.0
configuration options saved in the Bump-Calibration Station, press Read.
R
firmware file.
100
R
R
firmware file will be saved to the USB Disk of the Bump-Calibration Station.
100
R
R
[34-2900-0513-2 ]
monitors. There are fields available for H2S, CO,
100
R
R
firmware. The Bump-Calibration Station can keep a
100
R
R
monitors require a firmware file that is specific to the
100
R
R
17 |
P a g e
Advertisement
Table of Contents
