Intellichlor "Dummy" Cell; Connecting The Cell Power Cable To The Power Center - Pentair INTELLICHLOR IC15 Installation And User Manual

24
®
IntelliChlor SCG "Dummy" Cell
After new pool construction has been completed, in order to prevent debris from entering the IntelliChlor Salt
Chlorine Generator , it is recommended that the IntelliChlor
(P/N 520588) be installed before installing the IntelliChlor Salt Chlorine Generator . After the pool system has
flushed the debris from the pipes, remove the "dummy cell" and install the IntelliChlor Salt Chlorine Generator.
Selecting Model Size
IntelliChlor SCG (Model IC15)
Chlorine Production: The equivalent of 0.278 kg of pure chlorine per 24 hour period of pool pump
run time.
Residential Pools: One unit per 56,800 L (15,000 Gal), Residential Spas: One unit per 55 600 L
(14,688 Gal).
Installing the IntelliChlor SCG Cell
Install the IntelliChlor cell assembly no closer than 1 metre (three (3) feet) away from the heater outlet, if used.
For more information see plumbing diagrams on page 4 and 5.
Note: For best flow sensing, provide at least 3 0 - 4 5 c m ( 12"-18") of straight pipe in front of the cell inlet.
Note: After new pool construction has been completed, in order to prevent debris from entering the
IntelliChlor cell assembly, it is recommended that the IntelliChlor pass-through cell (P/N 520588) be
installed before installing the IntelliChlor cell. After the pool system has flushed the debris from the pipes,
remove the pass-through cell and install the IntelliChlor cell.
Note: Pipe couplings: Schedule 80, maximum pressure 5 1 7 k P a ( 7 5 p s i ) at 21° C (70
To install the IntelliChlor cell:
1. Using PVC glue, mount the PVC couplings to the plumbing pipe. Allow the glue to dry.
2. Mount the cell to allow access to the control panel. Install the cell onto the couplings.
Ensure the O-rings are seated properly.
3. Switch on the pump and visually inspect for leaks around the couplings.
Connecting the IC15 Cell Power Cable to the Power Center
WARNING - Switch OFF main system power to the Power Center before making any connections.
Be sure that AC power is switched OFF before connecting the power cord to the Power Center.
Aft r the IC15 cell installation is completed, connect the cell power cable to the Power Supply:
e
•
Align the four (4) pins of the cell power cord connector with the socket on the side of the Power
Supply and insert the connector. Turn the round socket nut until it locks the connector in place.
Power Supply connector
IntelliChlor Salt Chlorine Generator Installation and User's Guide
®
Salt Chlorine Generator "dummy" cell
IC15 Power Center
°F).