Section 1: Intellichlor Scg Control Panel; Salt Level Status Leds; Status Leds - Pentair INTELLICHLOR IC15 Installation And User Manual

Salt Level

Status LEDs

The SCG salt level checks the pool water daily and displays the levels as follows:
Green LED: Good salt. The pool water salt level is between 2800 ppm
and 4500, and the SCG is producing chlorine. SCG salt LED should
always be showing GREEN level for better results.
Green LED (Flashing): Salt level is above 4500 ppm. Chlorine is being
produced but the salt level is too high which increases the risk of
corrosion and deterioration of pool equipment and surfaces in and around
the pool. Pool water needs to be drained and refilled 30 cm (1ft) at a time
until the salt level is below 4500 ppm.
Red LED: Low salt. The water salt level is below 2800 ppm. The SCG
will be producing chlorine at reduced efficiency. It is highly recommended
to add salt. See (*) Note below.
Red LED: Very low salt. The water salt level has fallen below 2600 ppm.
The SCG will not produce chlorine until salt is added. The SCG is OFF.
See (*) Note below.
NOTE (*): After every salt addition, pump should be allowed to run for
at least 24 hours for proper dilution. Salinity readings should only be
taken, after the dilution period.
DO NOT take salinity readings during the dilution period, otherwise
readings WILL NOT be accurate.
Status LEDs
Cold Water: Shows the IntelliChlor Salt Chlorine Generator power
status:
• No Light: .The SCG is operating in the normal temperature
range > 11° C (> 52° F).
• Red: The SCG is in "Standby" mode (system off, no chlorine
production) due to a cold water condition. The SCG will resume
to normal operation mode, including accurate salinity report,
once water temperature goes above 11° C (52° F).
Cell: Shows the status of the SCG.
• Green (flashing): The SCG needs to be inspected. The blades
may have calcium buildup. The SCG is not producing chlorine.
• Green: SCG is good and producing chlorine
No Light: SCG is off and not producing chlorine. It may be in an
off-period of the sanitizing cycle and will return on shortly. This
light will also be blank if the water temperature is below
11° C +/ 1.67° C (52° F +/-3° F). This cold water cutoff mode
extends the blade life.
Flow: This light indicates the status of water flowing through the SCG.
• Red: Insufficient water flow through the SCG, no chlorine is being produced.
• Green: Sufficient water flow to produce chlorine.
IntelliChlor
IntelliChlor Salt Chlorine Generator Installation and User's Guide
®
SCG Control Panel
7
Section 1