Preparation for outdoor unit installation
Moving the Outdoor Unit by Wire Rope
Fasten the outdoor unit by two 8m or longer wire ropes as shown at the
figure . To prevent from damage or scratches, insert a piece of cloth between
the outdoor unit and rope, then move the unit .
❋ ❋ The appearance of the unit may be different from the picture depending
on the model .
Deciding on where to install the outdoor unit
Outdoor Unit
f The outdoor unit must not be placed on its side or upside down, as the compressor lubrication oil will run into the cooling
f
circuit and seriously damage the unit .
f Choose a location that is dry and sunny, but not exposed to direct sunlight or strong winds .
f
f Do not block any passageways or thoroughfares .
f
f Choose a location where the noise of the air conditioner when running and the discharged air do not disturb any
f
neighbours .
f Choose a position that enables the pipes and cables to be easily connected to the indoor unit .
f
f Install the outdoor unit on a flat, stable surface that can support its weight and does not generate any unnecessary noise
f
and vibration .
f Position the outdoor unit so that the air flow is directed towards the open area .
f
f Maintain sufficient clearance around the outdoor unit, especially from a radio, computer, stereo system, etc .
f
Indoor Unit
Fuse
Stereo
f If the outdoor unit is installed at a height, ensure that its base is firmly fixed in position .
f
f Make sure that the water dripping from the drain hose runs away correctly and safely .
f
6
Control
300mm
200mm
Fuse
Outdoor Unit
Air Guide Duct
(This product is not
provided by Samsung)
Wire rope
Plate protection
cloth