Advertisement
7、control software related introduction
Parameter setting：
7.1、Print head Setting
7.1.1、users don't need to calibrate the print head by themselves due to the calibration has been done
before export in factory.
7.1.2、
7.1.3、 Carriage speed： there are 3 mode speed of the carriage: speed 1,speed 2、 speed 3 （Low speed、 medium
speed、High speed）
7.1.4、Two-way Adjust：If you choose double direction in Usually Parameter setting. need to adjust two-way
value。To confirm the printing start line if align or not, click testing, you will see the following printing：
If the up and down line keep alignment at a digital, it means the two-way value is the one; you should type the
digital to the Two-way value. For example, in the above printing, the up and down line keep alignment at digital
9, then you should type 9 into the two-way adjust.
7.2、Adjust print head：
7.2.1、Check Nozzle：see introduction of Tool Menu
7.2.2、Single Print head Adjust：Adjust the X axis of single print head 1901
Click print head adjust, if the above situations happened, it means the installation of X axis of print head is
Tel：+86-760-88667089 / 88667090
Fax：+86-760-88667096
Web: http://www.titanjet.com.cn
email:sales@titanjet.com.cn
Add：No.6-2,Jin Hua Zhong Road,Zhongshan City,Guangdong,China
Single print head printer no need to adjust.
http://www.titanjet.com.cn
- 31 -
Advertisement
