Table of Contents
Advertisement
ADVANCED COMMUNICATIONS & SENSING
17.4
Reading the sensor using the GUI
By default, if no configuration file is loaded the SX8724S state should look like in the picture beside.Press the
"Set Default" button to start a default continuous acquisition mode to enable the acquisition chain.
17.5
Reference Voltage Selection
After having pressed the "Set Default" button as described in
GUI sets the input reference (VMUX) to VREF (V
the acquisition chain. The "Reference" configuration control should look like the picture below
ACS - Revision 1.0
© Semtech Corp.
Press the Set Default button here
Figure 34. SX8724S default state
Figure 35. Reference Voltage Selection
May 2011
Evaluation Kit for SX8724S Data Acquisition System
"17.4 Reading the sensor using the
-V
). Change this and select V
REF
SS
Page 40
SX8724SEVK
USER GUIDE
as voltage reference for
BATT
www.semtech.com
GUI", the
Advertisement
Table of Contents
