Connection Of Wire Feeders With Control Cable (14 Pin - Lincoln Electric Dual Maverick 450 Operator's Manual

DUAL MAVERICK ® 450
CONNECTION OF WIRE FEEDERS WITH CONTROL
CABLE (14 PIN)
WARNING
Shut off welder before making any electrical connections.
CONNECTION OF LF-72, LF-74, FLEX FEED 74 HT,
FLEX FEED 84, LN-25 PRO DUAL POWER TO THE
®
DUAL MAVERICK 450
Note: The Dual Maverick 450 can operate two different wire
feeders at the same time.
• Shut the welder off.
• Set the "WIRE FEEDER VOLTMETER" switch to either "+" or
"-" as required by the electrode being used.
• For electrode Positive, connect the electrode cable to the "+"
terminal of the welder and work cable to the "-" terminal of
the welder. For electrode Negative, connect the electrode
cable "-" terminal of the welder and work cable to the "+"
terminal of the welder.
• Using the display Set "MODE" to MIG/FCAW.
• Adjust the "PINCH" setting to desired Crispness. SOFT for MIG
and CRISP for Innershield.
• Set the "Weld Output Override" to the desired settings using
the display.
• Connect the 14 pin control cable from the wire feeder to the
engine drive (See Figure A.5).
• This procedure can be done for both "Single" and "Dual"
operator modes.
A
WIRE FEEDER
FIGURE A.5
A
Operator
K1797-xx
CABLE
B
Operator
ENGINE WELDER
A-10
INSTALLATION
WIRE FEEDER
K1797-xx
CABLE
B