Ecoplus ZR9W-250T Instruction Manual page 32

.CONTROLLER INTRODUCTION .CONTROLLER INTRODUCTION
5 How to connect your heat pump to WIFI
#
5.2 2 Method
5.2.9 a. If you have linked/set up your heat pump to internet ,and want to reset , but the setting on
"SmartLink3 Demo" failed, You can access to 1.2 WIFI query and press "Initialization",
input password "8912", reinitialize the set up process ,as to make sure the WIFI signal
appear again.
b. When your internet connection disconnected during your setup by the 2nd method , you can
also access to 1.2 WIFI query and press "Initialization", input password "8912", reinitialize
the set up process ,as to make sure the WIFI signal appear again.
5.3 Important Notice:
5.3.1 Make sure the heat pump installation side covered with WIFI internet signal.
5.3.2 Each step during the set-up process needs to press "confirm" to continue. After the set-up
finished, you don't need to set up again even heat pump is restart, unless the router address has
changed, then you need to re-set up again.
5.4 Fast Inquiry
5.4.1 After WIFI set-up finished, you may access to following website
http://app.xlink.cn:9001/query.html
query /check the heat pump status or to change parameter settings.
5.4.2 MAC code and heat pump barcode can be found on heat pump (normally it shall be on back
side of wire controller, if you cannot find it, please contact us )
5.4.3 All the heat pump data will be uploaded every minute .
5.4.4 Each parameter amendment on website require to press "push" and " confirm" to proceed.
Fast Enquiry QR code
Fast Enquiry can only access to one unit.
Dealer website can access to all units belong to the same dealer.
,and input MAC code and heat pump barcode number to
Dealer website QR code:
29