Matan Digital Printing Barak Series Technical Notes page 11

17. From time to time, bend the black ink pipe end to block the
18. Let the flushing fluid drain out until the color becomes
19. Turn off and disconnect the external pump.
20. To clean the machine's pump which belongs to the channel
21. Connect a piece of black ink tube to the upper side of the
22. Externally supply 24 volt to the machine pump (using the
23. Let the flushing fluid flow through the P
24. Disconnect the piece of black ink pipe connected to the
25. Replace all old fittings, using a #12 metric wrench.
26. Reconnect the V
10100125 - A
ink drain, as shown below, so that the flushing fluid will
drain through the P
clear.
of the SIT that you already cleaned, insert the lower fitting
of the P I F
RIMARY NK ILTER
fluid bottle, using a piece of black ink pipe.
machine pump and insert the other end into an empty
bottle.
same cable you used for the external pump).
and the machine pump for a few seconds, until clean
flushing fluid begins to drain out from the machine pump
into the empty bottle.
SIT's vacuum fitting.
ACUUM
© Matan Digital Printers Ltd
H nozzles.
RINT EAD
, directly to the external flushing
P to the SIT.
IPE
I F
RIMARY NK ILTER
Page 11 of 19