Setting The Node Name - Digital Equipment VAX 4000 Model 100 Operator Instructions Manual

C.3.4 Setting the Node Name
After entering the DUP driver utility for a specified device, you can examine
and set the node name for the device as follows.
1. At the
PARAMS>
ISE to which you are currently connected.
2. Enter
SET NODENAME SYSDSK
of up to eight characters).
3. Enter
SHOW NODENAME
This shows the steps for changing the node name of a specified device from the
factory-supplied name to SYSDSK.
PARAMS>SHOW NODENAME
Parameter Current
--------- ---------------- ---------------- -------- -----
NODENAME
PARAMS>SET NODENAME SYSDSK
PARAMS>SHOW NODENAME
Parameter Current
--------- ---------------- ---------------- -------- -----
NODENAME
C.3.5 Setting the System ID
This parameter is modified only when replacing a device. Only Digital
service representatives and licensed self-maintenance customers should
remove devices. All parameters for the replacement device should be
programmed to match those of the original device.
After entering the DUP driver utility for a specified device, you can examine
and set the system ID for the device as follows.
1. At the
PARAMS>
device to which you are currently connected.
2. Enter
SET SYSTEMID System ID
system ID).
3. Enter
SHOW SYSTEMID
prompt, enter
SHOW NODENAME
(or enter the desired alphanumeric node name
to verify the new node name.
Default
R7CZZC RF73
Default
SYSDSK RF73
Note
prompt, enter
SHOW SYSTEMID
(enter the desired serial number-based
to verify the new system ID.
Programming Parameters for DSSI Devices C–9
to check the node name of the
Type Radix
String Ascii B
Type Radix
String Ascii B
to check the system ID of the