Setting The Unit Number - Digital Equipment VAX 4000 Model 100 Operator Instructions Manual

PARAMS>SHOW ALLCLASS
Parameter
--------- ---------------- ---------------- -------- -----
ALLCLASS
PARAMS>SET ALLCLASS 2
PARAMS>SHOW ALLCLASS
Parameter
--------- ---------------- ---------------- -------- -----
ALLCLASS
C.3.3 Setting the Unit Number
After entering the DUP driver utility for a specified device, you can examine
and set the unit number for the device as follows.
1. At the
PARAMS>
the ISE to which you are currently connected.
2. Enter
SET UNITNUM 10
3. Enter
SET FORCEUNI 0
by the bus node ID plug.
4. Enter
SHOW UNITNUM
5. Enter
SHOW FORCEUNI
parameter is 0.
This shows the steps for changing the unit number of a specified device
from 0 to 10.
PARAMS>SHOW UNITNUM
Parameter
--------- ---------------- ---------------- -------- -----
UNITNUM
PARAMS>SET UNITNUM 10
PARAMS>SET FORCEUNI 0
PARAMS>SHOW UNITNUM
Parameter
--------- ---------------- ---------------- -------- -----
UNITNUM
PARAMS>SHOW FORCEUNI
Parameter
--------- ---------------- ---------------- -------- -----
FORCEUNI
6. Label the device with its unit number, using the unit number labels
shipped with your system.
C–8 Programming Parameters for DSSI Devices
Current Default
0
Current Default
2
prompt, enter
SHOW UNITNUM
(or enter the unit number you desire).
to override the default unit number value supplied
to verify the new unit number.
to verify that the current value for the
Current Default
0
Current Default
10
Current Default
0
Type Radix
0 Byte Dec B
Type Radix
0 Byte Dec B
to check the unit number of
FORCEUNI
Type Radix
0 Word Dec
Type Radix
0 Word Dec
Type Radix
1 Boolean 0/1
U
U
U