Installing And Configuring Fronius System Monitoring; Safety; Software Version Of The Fronius System Monitoring; Using For The First Time - Fronius Symo Hybrid Installation Instructions Manual

Installing and configuring Fronius system monitor-
ing

Safety

Software version In order for the external battery to be supported, a software version of at least 1.9.x-x is
of the Fronius required. Instructions for updating can be found at www.fronius.com. There must be an on-
system monitor- line connection for the duration of the update process. The current version of the system
ing monitoring can be seen via the info symbol:
Regardless of the software version that is displayed in the web interface, the update to the
latest software version may comprise several update steps. Both the inverter and the bat-
tery can be updated during the update process.
Using for the first
time
or
„https://wizard.solarweb.comvisit "https://wizard.solarweb.com"
Important! In order to establish a connection to Fronius system monitoring, the end device
in question (e.g. laptop, tablet, etc.) must be set up as follows:
-
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
NOTE! Knowledge of networking systems is required in order to install Fronius
system monitoring.
NOTE! The Fronius Solar.web App makes it much easier to set up Fronius sys-
tem monitoring when using it for the first time.
The Fronius Solar.web App is available in the relevant App store.
"Obtain IP address automatically (DHCP)" must be activated
27