Configuring The System; Venting Pumps And Ts Stratification Cylinder; Venting Feed/Heating Circuit Pump; Vent Heating Circuit Of The Ts Stratification Cylinder - Wolf COB-2 Operation Instructions Manual

Commissioning
6.5 Configuring the system
BM-2 programming unit installation and operating instructions for contractors
AM display module installation and operating instructions for contractors
The commissioning assistant provides assistance with the following settings:
– Standard settings (language, date, time)
– User interface simplified / extended
– Heating appliance configuration
– Configuration of the modules embedded in the eBus
– System configuration
– Service message
– Pasteurisation function (start time)
– Maximum DHW temperature
– Set flue gas values
– Heating circuit pump venting
– Oil pump venting
– Screed drying
✔ The commissioning assistant is closed automatically after the final configuration.
► To open the commissioning assistant again, perform a reset of the control module.
i
A parameter reset is only possible for control modules connected to the heat generator.
6.6 Venting pumps and TS stratification cylinder
6.6.1

Venting feed/heating circuit pump

Installation instructions for feed/heating circuit pump
► Check the system pressure.
System pressure over 1.5 bar:
✔ heating circuit is completely vented.
System pressure below 1.5 bar:
► Top up with water.
► Vent the feed/heating circuit pump again.
6.6.2 Vent heating circuit of the TS stratification cylinder
► Activate the DHW demand.
► Set the ON/OFF switch of the cylinder primary pump to venting.
► Vent the system completely at the maximum system temperature.
► Set the cylinder primary pump to constant pressure again.
Fig. 6.3 Cylinder primary pump
ON/OFF switch
q
Venting
w
50 | WOLF GmbH
(7.2.21 HG40: System
(7.2.24 HG47/49: CO
(6.6.3 Venting the oil pump)
(6.6.3 Venting the oil pump)
r
configuration)
setting)
2
w
q
e
Constant diff. pressure
e
Variable diff. pressure
r
3066501_201910