Connecting The Condensate Drain; Connecting The Trap; Connecting The Condensate Pump - Wolf COB-2 Operation Instructions Manual

Installation
► use an I/O module (extension module) for two configurable inputs/outputs (accessory).
► Connect anti-lift valve to output A3.
► Connect and configure A3
Alternative:
► Use the adaptor plug.
► Connect the adapter between the oil pump motor and the motor plug.
5.8

Connecting the condensate drain

DANGER
Escape of flue gases!
Risk of asphyxiation or severe to life-threatening poisoning.
► The trap and neutralising box must be filled with water prior to commissioning.
5.8.1

Connecting the trap

► Remove the sealing plug on the trap plug so that the condensate can drain freely. Otherwise, this
leads to an operating fault.
► Connect the trap to the connectors on the combustion chamber pan.
► Connect a drain hose to the trap and the on-site drain.
► Make sure that the line has a consistent downward incline and is properly ventilated.
Fig. 5.11 Trap with drain hose
Trap
q
5.8.2

Connecting the condensate pump

► Feed the drain hose of the trap into the condensate pump.
► Connect the condensate pump and the on-site drain.
Fig. 5.12 Trap with condensate pump
Trap
q
36 | WOLF GmbH
(7.2.27 HG58: Output A3).
w
w
Drain hose
Condensate pump
q
w
q
w
q
3066501_201910