Performing The Configuration - Auerswald TFS-Dialog 400 Advanced Information

Performing the configuration

Requirement:
• An internal telephone with DTMF signalling configured for the PBX
1. Press the keys on the device as shown in the figure.
*
* Press and hold the key until the display changes
2. Pick up the telephone receiver within 4 minutes.
3. Dial the internal number
This establishes the connection.
4. Dial * PIN *.
You will hear the confirmation tone (five rapid, sequential sounds).
5. Specify a function and a value (see Chapter Short reference >
Configuration in configuration mode (page
TFS-Dialog 400 - Advanced Information V01 10/2017
*
of the device.
Configuration via an internal telephone
43)).
Configuration
37