Other Pbxs - Auerswald TFS-Dialog 400 Advanced Information

terms of the call targets and the call duration – entirely by the PBX. The
default destination numbers (31–34) in the device must not be modified.

Other PBXs

In the COMpact 4000, 5000/R and COMmander 6000/R/RX PBXs with a
firmware version later than 6.4A, and in other Auerswald PBXs, device
templates are not supported. The door terminal must be configured as an
analogue subscriber here.
Note: CLIP info must be switched off for the analogue subscribers in
question (under Subscriber (scr.) > Properties > Analogue settings).
Otherwise, errors may occur when the door is called.
Make sure that the busy signal is switched on for call end for the
analogue subscribers in question.
To configure the device for PBXs from other manufacturers, please
consult the corresponding instructions.
TFS-Dialog 400 - Advanced Information V01 10/2017
Configuring the door terminal in the PBX
Configuration
31