Table of Contents
Advertisement
Quick Links
This user's guide describes the function and use of the DAC90x evaluation module (EVM). Included in this
document are a quick-start guide, instructions for optimizing evaluation results, jumper and connector
descriptions, software description, and alternate hardware configurations.
......................................................................................................................
1
1.1
1.2
1.3
1.4
2
2.1
2.2
2.3
2.4
3
3.1
3.2
3.3
1
2
3
4
5
6
7
1
2
3
4
5
6
Trademarks
Microsoft, Windows are registered trademarks of Microsoft Corporation.
All other trademarks are the property of their respective owners.
SLAU726 - August 2017
Submit Documentation Feedback
.................................................................................................
..................................................................................................
..........................................................................................................
............................................................................................................
................................................................................................
.......................................................................................
.........................................................................................
.......................................................................................
........................................................................................
.......................................................................................................
.......................................................................................
............................................................................................
............................................................................
List of Figures
...............................................................................................
.....................................................................................................
......................................................................................................
.................................................................................................
.................................................................................................
.......................................................................................
......................................................................................................
List of Tables
...........................................................................................................
........................................................................................................
..............................................................................
....................................................................................................
...............................................................................................
.............................................................................................
Copyright © 2017, Texas Instruments Incorporated
DAC90x Evaluation Module
Contents
.............................................................
User's Guide
SLAU726 - August 2017
DAC90x Evaluation Module
2
2
3
3
3
4
4
5
6
8
9
9
10
10
12
2
3
5
6
7
9
10
7
8
12
12
13
13
1
Advertisement
Table of Contents
Related Manuals for Texas Instruments DAC90 EVM Series
Summary of Contents for Texas Instruments DAC90 EVM Series
-
Page 1: Table Of Contents
J4 and J2 Power Connectors Trademarks Microsoft, Windows are registered trademarks of Microsoft Corporation. All other trademarks are the property of their respective owners. SLAU726 – August 2017 DAC90x Evaluation Module Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 2: Overview
5 VA AGND -5 VA 3.3 V (DV DGND *Unpopulated components Copyright © 2017, Texas Instruments Incorporated Figure 1. DAC90xEVM Block Diagram Required Hardware The following equipment is included in the EVM evaluation kit: • DAC90xEVM The following list of equipment are items that are not included in the EVM evaluation kit but are items required for evaluation of this product in order to achieve the best performance: •... -
Page 3: Required Software
High-Speed Data Converter Pro software (SLWC107) and User's Guide (SLWU087), available at www.ti.com/tool/dataconverterpro-sw NOTE: Schematics, layout, and BOM are available on each EVM tool page on www.ti.com: • DAC900EVM • DAC902EVM • DAC904EVM • DAC908EVM SLAU726 – August 2017 DAC90x Evaluation Module Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 4: Quick-Start Guide
TI website. 2. Extract the files from the zip file. 3. Run setup.exe and follow the installation prompts. DAC90x Evaluation Module SLAU726 – August 2017 Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 5: Hardware Setup Procedure
4. Turn on the power supply. Flip the power switch (SW7) to the ON position. The board should draw around 0.5 A after power up. This will increase to around 1.7 A when loaded with firmware. SLAU726 – August 2017 DAC90x Evaluation Module Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 6: Software Setup Procedure
The software can be opened and configured once the hardware is properly setup. 2.3.1 HSDC Pro GUI Configuration 1. Open High Speed Data Converter Pro by going to Start Menu → All Programs → Texas Instruments → High Speed Data Converter Pro. The GUI main page looks as shown in Figure DAC90x Evaluation Module SLAU726 –... -
Page 7: Hsdc Pro Gui Main Panel
DAC in order to meet setup and hold time requirements. If no output is seen, then see Quick Start Troubleshooting. SLAU726 – August 2017 DAC90x Evaluation Module Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 8: Quick-Start Troubleshooting
Verify jumper configurations are in default locations. Verify that filters are used in the clock and input signal paths and that low-noise signal sources are used. DAC90x Evaluation Module SLAU726 – August 2017 Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 9: Alternate Hardware Configurations
INT/EXT pin is tied to 5 V ( W3 pins 2 and 3 shorted) and the W4 jumper is in place, the external 1.2-V Vref is selected. SLAU726 – August 2017 DAC90x Evaluation Module Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 10: External Clock Generation
In addition to the transformer-coupled output configuration, the DAC90xEVM offers three more configurations which use the THS3001 operational amplifier. The THS3001 can be configured as a difference amplifier, an inverting amplifier, and a non-inverting amplifier. DAC90x Evaluation Module SLAU726 – August 2017 Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... - Page 11 W6 position A or W7 position E. If the input is via W6 position A, the output voltage is 2 V. If the input is taken via W7 position E, the output voltage at J7 is 2 V. SLAU726 – August 2017 DAC90x Evaluation Module Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated...
-
Page 12: Appendix A Jumper And Connector Descriptions
Supplies power to the EVM Input control signals used to create EVM chip select Input for a clock signal source J6, J7, J8, J9 DAC output signal Jumper and Connector Descriptions SLAU726 – August 2017 Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... -
Page 13: J1 Parallel Data Connector
Pin Number Function J2–1 Digital power 3 V–5 V J2–2 DGND J4–1 Analog power +5 V J4–2 AGND J4–3 Analog power –5 V SLAU726 – August 2017 Jumper and Connector Descriptions Submit Documentation Feedback Copyright © 2017, Texas Instruments Incorporated... - Page 14 STANDARD TERMS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, and/or documentation which may be provided together or separately (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms set forth herein.
- Page 15 FCC Interference Statement for Class B EVM devices NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 16 【無線電波を送信する製品の開発キットをお使いになる際の注意事項】 開発キットの中には技術基準適合証明を受けて いないものがあります。 技術適合証明を受けていないもののご使用に際しては、電波法遵守のため、以下のいずれかの 措置を取っていただく必要がありますのでご注意ください。 1. 電波法施行規則第6条第1項第1号に基づく平成18年3月28日総務省告示第173号で定められた電波暗室等の試験設備でご使用 いただく。 2. 実験局の免許を取得後ご使用いただく。 3. 技術基準適合証明を取得後ご使用いただく。 なお、本製品は、上記の「ご使用にあたっての注意」を譲渡先、移転先に通知しない限り、譲渡、移転できないものとします。 上記を遵守頂けない場合は、電波法の罰則が適用される可能性があることをご留意ください。 日本テキサス・イ ンスツルメンツ株式会社 東京都新宿区西新宿６丁目２４番１号 西新宿三井ビル 3.3.3 Notice for EVMs for Power Line Communication: Please see http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page 電力線搬送波通信についての開発キットをお使いになる際の注意事項については、次のところをご覧ください。http:/ /www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page 3.4 European Union 3.4.1 For EVMs subject to EU Directive 2014/30/EU (Electromagnetic Compatibility Directive): This is a class A product intended for use in environments other than domestic environments that are connected to a low-voltage power-supply network that supplies buildings used for domestic purposes.
- Page 17 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2017, Texas Instruments Incorporated...
- Page 18 IMPORTANT NOTICE FOR TI DESIGN INFORMATION AND RESOURCES Texas Instruments Incorporated (‘TI”) technical, application or other design advice, services or information, including, but not limited to, reference designs and materials relating to evaluation modules, (collectively, “TI Resources”) are intended to assist designers who are developing applications that incorporate TI products;...
- Page 19 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Texas Instruments DAC900EVM DAC902EVM DAC904EVM DAC908EVM...
Need help?
Do you have a question about the DAC90 EVM Series and is the answer not in the manual?
Questions and answers