Sony DCR-TRV16 Service Manual page 25

[SERVICE POSITION TO CHECK THE VTR SECTION]
Connection to Check the VTR Section
To check the VTR section, set the VTR to the "Forced VTR power ON" mode.
Operate the VTR functions using the adjustment remote commander (with the HOLD switch set in the OFF position).
Setting the "Forced VTR Power ON" mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 0, address: 10, and set data: 00.
3) Select page: D, address: 10, set data: 02, and
press the PAUSE button of the adjustment remote
commander.
To eject the cassette, connect Pin wd of the
CN1501 on the VC-281 board to Pin w;
(GND) of the CN1501 on the VC-281 board
for a second.
Note: Be sure to enter the "Forced VTR
power ON" mode when ejecting the
cassette.
CN1501
1
2
24 23
Mechanism deck
JK-218 board
Adjustment remote
commander (RM-95)
DCR-TRV16/TRV16E/TRV18/TRV18E/TRV116E/TRV118E
Exiting the "Forced VTR Power ON" mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 0, address: 10, and set data: 00.
3) Select page: D, address: 10, set data: 00, and press
the PAUSE button of the adjustment remote commander.
4) Select page: 0, address: 01, and set data: 00.
VC-280 board
JK-217 board
2-15
Extension cable (100P)
(J-6082-352-A)
VA-117 board
CPC-8 jig
(J-6082-388-A)
AC power
AC IN
adaptor
Battery terminal
board (6P)