Table of Contents
Advertisement
SUBSCRIBER SETUP MENU
lMPORTANll
Be sure that the Central Station setup parameters have
bean programmed
(see Central Station Setup Menu) before proceeding
with these procedures. The unit wtll not operate otherwfae.
To enter the Subscriber Setup Menu, press "S" within 8 seconds of power-
up. When "S" is selected, a password prompt will appear (if programmed).
The password must be entered correctly on the first try. If not, the unit must
be powered off, then on again, and the mode selection procedure repeated.
When the password is accepted, the question "7720P (YIN)' will appear.
Press "Y" or "N" according to the terminal being used.
~
questions
'hen
a,i questions 'ave
been
Press 'Y" to begin the series of Subscriber Setup
answered, the screen will again disptay the fist of
current parameters and offer the oppotiunfty to
make changes or exit the programming mode (by
pressing "Nm). When "Y" is pressed, the following
questions appear one at a time
SUBSCRIBER INFORMATION
~
Enter the customer's four-digit ID number, using
leading zeroes if required, and press RETURN.
m
{CS# ERROR] or {Pvt
Chan Error}
Did Not Verify
7920 NOT RUN
Until R*P
This entry is used as a verification to prevent
unauthorized
users from altering parameters.
Alarm Net users enter the Central
Station ID
number, Private System users enter the assigned
channel number. Once the verification is accepted,
this question will no longer appear, unless the
central station
number or private channel
is
changed in the central station menu, in whmh case
this question must be answered before the unft will
operate. An incorrect entry displays the follow"ng
If this message appears, programming can still be
completed, but the unit will not return to No~al
mode when finished. Rather, it will dsplay thii error
message again. To clear the error, the correct ID or
channel number must be entered.
Enter the Private System routing code (i used) .
Refer to the No. 7610/7910 Master Station manual
for routing code information. This message does
not appear for AlarmNet users.
- 14-
Advertisement
Table of Contents
