Table of Contents
Advertisement
~
Control outputs are normally low but can be
programmed to be normally high. Enter the control
outPuts which are to be at a normally high output
level
(refer
to the
Summary
of- C&nactions
diagram for identifying the control output terminefe).
When entered, the display again fists afl current
parameters, as shown at the beginning of this
section.
~"
Press "W if the controf output provided (TB1-2)
is to be at a normally high output level. Press
"N" if the control output is to be normsfly low. If
this option is not req-uired,this question-can be
bypassed by pressing RETURN.
Note that if
the '4 Cntrl fines (Y/N)' question is answered
with a "Y, thii question is omitted. If changing
from
4 control
lines
back
to only one
(answering "Na to the "4 Cntrf Lines" question),
this question must be answered with "Y" or
'Nm. Pressing RHURN
(instead of "Y= or 'W)
will reta"n the prevfousfy programmed control
fines settings. When 'W or "N' is pressed, the
display returns to the list of current parametem
(unless
7720P
is used)
shown
at the
beginning of thff section.
- 16-
Advertisement
Table of Contents
