Table of Contents
Advertisement
CENTRAL STAT#ON SETUP MENU
lNTRODUCllON
Prior to installation, the 7920SE must be programmed w"ti Central Station
parameters. To enter this programming mode, press "C- at the terminal
within 8 seconds of power-up or "X key reset. A password prompt will appear
'(if previously programmed). This password must be entered correctfy on the
first try. If not, the unit must be powered off, then on, and the mode sefactiin
repeated. When the password is accepted, the 'CHANGE PASSWORD?"
question appears (described earlier). When password programming is
completed (or bypassed by answering "N"), and the '7720P(Y/N)' question is
displayed.
Followed by
CENTRAL STATION SETUP PARAMETERS QUESTfONS.
NETWORK OPTfONS
If changes
are desired,
or the unit is being
programmed for the first time, press 'Y, which W
begin a series of questions.
Press "N" when
programming is complete. This will reset the unit
(as if powered off/on) and allow entry into another
programming mode. The unit will return to Normaf
mode if no entry is made w.hhinthe 8 seconds.
Press "Y if the security radio netwo~ is using an
odd flag. "Ngif the system is using en even flag.
Press W' if the subscriber is part of the AfarmNet
security system.
Press "N" for Private System
subscribers. Note
that
the
Subscriber
Menu
'VERIFY" question must be answered before the
unit will operate.
AlarmNet
users answer the
following:
Enter the assigned channel designation.
Selecting A, B, C or D will set the 7920SE to
the standard AlarmNet channel combinations.
Selecting "E" will allow the user to enter
channels
of operation
manually.
After
selecting "E", the user will be prompted for
Primary and Secondary channel numbers.
If "E" is selected, an AlarmNet Representative
will
inform
you
on the
proper channel
selections.
If
"E" is entered,
answer the
following
~
prompt
Enter the 2-digit Primary Channel # after this
- 12-
Advertisement
Table of Contents
