Philips L01.1L AC Service Manual page 19

4.3.2 Top Control Assy/Board (if present)
M
Figure 4-3 Top control removal
1. Remove the two fixation screws (if present).
2. Pull the module down and backwards (w.o.w. release it
from the front hinge [M]). You must use some force.
3. Lift the board from its bracket while releasing the two
fixation clamps. The board hinges on the other side.
4.3.3 Front Interface Assy/ Board (if present)
1
2
3
Figure 4-4 Front interface removal
1. You can remove the complete module from the bottom
plate, by pulling the two fixation clamps upwards [1] while
sliding the module away from the CRT [2].
2. Release the 2 fixation clamps [3] at the side of the bracket,
and lift the board out of the bracket (it hinges at one side).
4.3.4 DAF Assy/ Board (if present)
2
Figure 4-5 DAF panel removal
Top control board
CL 06532012_003.eps
1
3
CL 06532130_018.eps
1
4
3
3
CL 26532119_060.eps
181202
Mechanical Instructions
1. You can remove the complete module from the Main
Carrier bracket, by pressing its fixation clamp downwards
[1] while sliding the module in the direction of the CRT [2].
2. Release the 2 fixation clamps [3] to lift the board out of the
bracket [4].
4.3.5 Side I/O Assy/ Board (if present)
030200
1. You can remove the complete Side I/O assembly after
removing the 2 fixation screws.
2. Release the 2 fixation clamps to lift the board out of the
bracket.
4.4 Set Re-assembly
Before you mount the rear cover, perform the following checks:
021000
1. Check whether the AC power cord is mounted correctly in
its guiding brackets.
2. Re-place the strain relief of the AC power cord into the
cabinet.
3. Check whether all cables are replaced in their original
position.
L01.1L AC
CL 06532012_004.eps
Figure 4-6 Side jack panel removal
4. EN 19
030200