Attaching The Accessories; Attaching The Holder Plate - Star Micronics TSP100 Hardware Manual

The following accessories do not necessarily have to be attached.
Attach them if necessary.
• Holding plate
• Rubber feet
• Switch cover

4-1. Attaching the Holder Plate

4. Attaching the Accessories

(1) Attach the holding plate to the printer.
Then tighten the two screws that were
supplied to secure it in place.
(2) Position the printer over the screws, etc.,
on the wall and then slide it downward to
set it in place.
(3) Push the cover open lever, and open the
printer cover.
(4) Insert the roll paper as shown.
– 18 –