Star Micronics TSP400Z Series User Manual page 14

Pause at a: HEX dump
Pause at b: sensor selection
Press ON LINE
Press FEED
Pause at c: command mode selection
Press ON LINE
Press FEED
3) Power + ON LINE + FEED switches
(Turn the power on while holding the ON LINE and FEED switches depressed.)
Approx.
2 sec.
1 short beep ... 2 short beeps ... 3 short beeps ... 1 long beep ...
a
HEAD UP NO PAPER
LED
lights up
Pause at a: RAM backup cleared
Pause at b: feed function selection
Press ON LINE
Press FEED
Pause at c: sensor adjustment mode
Pause at d: no operation
Pause at e: clearing of all memory switches and test print
1 At e, release the ON LINE switch and FEED switch in 2 seconds
or less (all LEDs go off).
2 Press the ON LINE switch and FEED switch in 2 seconds or less,
and hold them depressed for at least 3 seconds (all LEDs light up).
3 Release the ON LINE switch and FEED switch.
4 The contents of all memory switches will be erased (all will be set
to 0).
After that, test print is carried out.
* If this process is interrupted midway, the printer will operate in
regular mode.
* After the memory switch settings are erased, the memory switches
must be set again, as appropriate for each model.
1 short beep
2 short beeps
1 short beep
2 short beeps
Approx.
2 sec.
b
ERROR
LED LED
lights up lights up
1 short beep
2 short beeps
Reflecting sensor
Transmissive sensor
Page mode
Line mode
Approx.
2 sec.
c
LEDs flash
successively
lights up
Top of Form disabled.
Top of form enabled.
– 11 –
Approx.
2 sec.
...
d e
All LEDs
light up