Line Feedbutton; Fwdadj Button; Revadj Button - Star StarJet SJ-48 User Manual

Star micronics printer users manual
Table of Contents

Advertisement

The printer powers up in the on-line status if paper is loaded. If paper is not loaded, the
printer powers up off-line with the
indicator illuminating and the
indicator
blinking. When you load paper, you must press the [ ON
[
button to set the printer
on-line.
You will want to press the I ONLINE ] button:
. Before and after any other panel operation
The other panel buttons operate in the off-line state. Press the I ONl-lNE ~buttonto go
off-line. After performing the panel operation(s), press the I ON
]
button againto
go back on-line.
. To pause during printing
If you press the I ON
I
button during printing, the printer stops printing and goes
off-line, allowing you to check the printout or change a control panel setting. Printing
resumes when you press the I ON
I
button again to go back on-line.
LINE FEED button
If you press this button while off-line, the paper will feed forward. If you hold the button
down, the printer will perform consecutive line feeds.
If you also press the I ON
]
button while you are line-feeding, the paper will eject
automatically the current page. This is explained later.
FWD ADJ button
For fine alignment, you can feed the paper forward in very small increments as follows:
1. Press the ~ ON
button to set the printer off-line.
2. press andholddownthe ~
button. Thepaperwill start advancing inaseries
of small steps. When you want to stop, release this button.
REVADJ button
You can also feed the paper in small increments in reverse, to return to a higher position
on the same page.
1. Press the I ON
button to set the printer off-line.
2. Press and hold down the I
]
button. The paper will start moving backwards
in a series of small steps. When you want to stop, release this button.
If you press this button while on-line, this will change the Print Quality between High
Quality (HQ) and Economy. You will hear one beep tone when the Economy mode is
selected, and twice when the HQ mode is selected. The print speed is the same in both the
Economy and HQ mode, but the Economy mode uses less ink.
When you select the Economy mode with this button, the printer ignores the Print Quality
commands from the computer, and prints all text and graphics with the Economy mode.

Advertisement

Table of Contents
loading

Table of Contents