Table of Contents
Advertisement
Top of form
When you power on the printer, the first line position is automatically set to the current
position.
If this is not where you want the top line of the page to be, you can change the top-of-form
position as follows:
1. Press the I
]
button to set the printer off-line.
2. Movethepapertothe desired top-of-form position bypressingthe I
]
button,
or by performing a forward or reverse micro-feed with ~
]
or ~
button.
3. Press the I ON
I
button to set the printer on-line.
4. While holding the
]
button down, press the I FW3
[
button, then
release both buttons at the same time. You will hear a beep tone indicating that the top-
of-form position has been set.
Head cleaning
The printer's unique head cleaning system clears paper particles and dust accumulated
around the print head nozzles that may otherwise cause printing problems. It also clears the
nozzles and helps maintain a high level of print quality. However, if printing problems such
as irregular dot print or dot missing should occur, perform the print head cleaning according
to the procedure below.
1. Make sure that the printer is turned on and the paper is loaded.
2. Press and hold down the I
]
and I
I
buttons while in on-line.
3. The
indicator blinks for five seconds while the print head is being cleaned.
The check pattern shown below can be printed by pressing one of any button within 1.5
seconds after pressing the I
{
and I
I
buttons.
NOTE: The printer does not print the check pattern when the data in the buffer is
retained.
When the print check is completed, the printer returns to normal status.
I
. . .
F
4
S
c
p
p
Chapter4 CONTROL PANEL OPERATIONS
23
Advertisement
Table of Contents
