Appliance details
3.3
Unpacking the heater
Before installing the unit, be certain you have the correct
heater for your type of Gas - Propane or Natural Gas.
Identification labels are found on the shipping box, and on the
rating plate which is located on the right side panel of the cover.
Fig. 2
Rating plate
[1] Serial number
[2] Type of gas
3.3.1 The box includes
•
940 ES
•
Bracket for wall hanging the heater
•
Installation manual (manual can be downloaded at
www.bosch-climate.us)
•
Product registration card
•
Energy Guide label (in the front cover)
Please complete and return the enclosed product registration
card.
The 940 ES is not approved or designed for:
•
Manufactured (mobile) homes, boats or any mobile
installation. (Modular homes are acceptable for
installation).
•
Use above 8000 ft A.S.L. altitude (see page 31).
•
Outdoor installation without installation of Outdoor kit
(BTOK).
•
Applications where inlet water temperature is higher
than 140°F (60°C). A 3-way valve or mixing valve must
be installed before the appliance if inlet water
temperature exceeds this limit.
12
3.3.2 Remove front cover
▶ Loosen the two Phillips head screws located on bottom rear
of cover.
Fig. 3
Loosen the two screws
▶ Lift front cover panel upward and remove.
Fig. 4
Remove the front cover
940 ES – 6 720 644 930 (2019/09)