Start Of The Cp 520; Batteries Installation - Batteries Replacement; Control Of The Paper Capacity; Switch On Of The Device - TAG Heuer CHRONOPRINTER 520 Operating Instructions Manual

3.1 Batteries installation – Batteries replacement
To open the battery cover, you can help you with your thumbs by strongly pushing it in the direction of
the arrow.
Introduce the batteries by respecting the polarities indicated at the bottom of the compartment.
3.2 Control if the paper capacity is still sufficient
To change the paper roll, refer to chapter 7 - CHANGING OF THE PAPER ROLL.
3.3 Switch on the CP 520 in pressing the key ON for 3 to 5 seconds
Two possibilities: either the printer is not activated and the CP 520 does not print (point 3.3.1), or it is
activated and the CP 520 prints (point 3.3.2).
3.3.1 The CP 520 does not print:
The display indicates:
You can visualize the parameters in pressing / and M or continue directly in pressing #.
Press #.
The display indicates:
If you wish to use the printer, make sure the batteries are in good state.
To switch on the printer, enter in the menu in pressing F and select PRINTER using the M,
confirm with #. Select PRINTER ON, press #. The CP 520 prints "PRINTER ON".
The display indicates again:
Please, continue in following the Point 3.4 – Synchronization (SYNCHRO).
3. START UP OF THE CP 520
P R E S S
P A R A M E T E R S .
O R
Page 4
C P 5 2 0
/ / / /
T O C H E C K
# T O C O N T I N U E
E N T E R T I M E
F O R S Y N C H R O
0 0 : 0 0
E N T E R T I M E
F O R S Y N C H R O
0 0 : 0 0