Stihl TS 420 Manual page 67

Ensure that the spring housing is
properly seated in the mount
(arrows).
If the rewind spring pops out during
installation, fit it in the spring
housing as follows:
1
– Arrange the spring (1) as shown
in the illustration.
: Position the anchor loop in the
fixture (arrow) in the spring
housing.
66
: Fit the rewind spring (1)
completely in a circular fashion,
working in clockwise direction.
– Secure the spring so that it
cannot pop out.
– Slide the spring housing into the
mount in the starter cover until it
engages there.
1
– Secure the rewind spring so that
it cannot pop out.
: If necessary, align the inner
spring loop (arrow) with suitable
pliers so that it rests against the
starter post at a slight angle.
– Install the rope rotor, b 9.4.
– Install the pawl, b 9.3.
– Grease the pegs on the pawl,
b 14.
– Tension the rewind spring,
b 9.6.
– Reassemble remaining parts in
reverse order.
– Tightening torques, b 3.5.
TS 410, TS 420