Stihl TS 420 Manual page 103

No. Part name
20 Wooden assembly block
21 Service tool ZS
22 Press arbor
23 Press arbor
24 Stud puller, M8
25 Assembly hook
26 Test disk
27 Dial gauge holder
28 Dial gauge
29 Torque wrench with optical/
acoustic signal
30 Torque wrench with optical/
acoustic signal
31 Socket, T27x125
32 Screwdriver T27x150
33 Pliers A10
34 Pliers C19
Remarks:
1) Use only for releasing.
102
Part No. Use
1108 893 4800 Locate piston
5910 007 2200 Remove crankshaft
4119 893 7200 Drive grooved ball bearings out of
spindle bearing
4224 893 7200 Drive grooved ball bearing out of poly
V-belt pulley
5910 893 0501 Unscrew studs for attaching the cast
arm with guard
5910 893 8800 Remove pickup body
5910 851 6100 Test axial truth of running of the cutting
wheel mount
5910 850 6000 Test axial truth of running
0000 890 9100 Test axial truth of running
5910 890 0302 Screw connections (0.5 to 18 Nm)
(with visual and acoustic signaling)
5910 890 0312 Screw connections (6 to 80 Nm)
(with visual and acoustic signaling)
0812 542 2104 Remove and install spline socket head
screws with electric or pneumatic
screwdrivers; tighten down screws with
torque wrench
5910 890 2400 IS-P screws (4 mm)
0811 611 8200 Remove and install external retaining
rings
0811 641 8380 Remove and install internal retaining
rings
Re-
marks
1)
1)
TS 410, TS 420