Stihl TS 420 Manual page 39

1
: Take out the screws (arrows).
– Remove the shroud (1).
– Examine the throttle trigger and
trigger interlock, replace if
necessary, b 11.2.
1
: Fit the shroud (1), guiding the
short circuit and ground wire with
switch through the opening
(arrow).
The wiring harness must be routed
in the guides in the air guide shroud,
b 7.4.
: Insert and tighten down the
screws (arrows).
38
1
– Fit the filter cover (1).
: Insert and tighten down the
screws (arrows).
1
2
– Take the throttle rod out of the
mount (arrow).
: Hook the throttle rod (1) into the
throttle trigger (2).
1
: Slide the switch (1) with retainer
into the mount (arrow).
The wires are routed through
underneath the mount.
– Insert and tighten down the
screw.
: First place the short circuit and
ground wires in the guide (1),
then in the other guide (arrow).
– Install the switch shaft and
handle molding, b 11.1.1.
1
: Press the grommet (1) into the
mount (arrow) until it is fully
home.
TS 410, TS 420
1