Rope Rotor - Stihl TS 420 Manual

1
: Position the spring (1) so that the
loop of the spring encloses the
peg of the pawl and the curved
part of the spring (arrow) is
located in the groove in the
starter post.
: Then slide the straight part of the
spring over the starter post until it
engages in the groove.
– Reassemble remaining parts in
reverse order.
9.4

Rope rotor

2
Relieve tension of rewind spring
– Remove the starter cover, b 9.2.
: Pull out the starter rope (1)
approx. 30 cm, then hold the rope
rotor (2) steady. The recess
(arrow) must point towards the
rope guide.
62
2
3
: Pull the starter rope (1) out
between the recess and rope
guide (arrow) with assembly
hook (2) 5910 890 2800.
– Hold the rope rotor (3) so that it
turns slowly until the tension of
the rewind spring has been
relieved.
1
1
: Pull out the rope (1) with the
starter grip and straighten it out.
– Remove the starter rope; remove
any remaining scraps of rope,
b 9.5.
The system will not be under
tension if the starter rope or rewind
spring is broken.
– Remove the spring and pull out
the pawl, b 9.3.
1
– Remove the washer.
The rewind spring must be relieved.
: Carefully pull off the rope
rotor (1). The rewind spring may
pop out.
– Examine the rope rotor, replace if
necessary.
– Coat the hole in the rope rotor
with STIHL special lubricant,
b 14.
1
TS 410, TS 420