Table of Contents
Advertisement
B8976111/02
4.2.1.17 Read Total Configuration
Meaning
With this command, the following data are read from the CP:
The list of active slaves (LAS). This indicates which of the connected slaves are activated.
±
The current configuration data of the connected slaves (I/O configuration and ID code).
±
The current parameters of the slaves (actual parameters).
±
The current flags.
±
This command can, for example, be used to find out the configuration of the slaves connected to the
AS-i cable after installation. The configuration data read in can be modified if required and saved as
the desired configuration on the CP 142-2 using the 'configure entire system' command (see Section
4.2.1.18.
Structure of the job data in the send buffer
Bit 7
Byte 0
1 H
Structure of the job data in the receive buffer
Bit 7
Byte 0
Byte 1
Byte 2
LAS slave 0 to 3
Byte 3
LAS slave 8 to 11
Byte 4
LAS slave 16 to 19
Byte 5
LAS slave 24 to 27
Byte 6
ID code slave 0
Byte 7
ID code slave 1
Byte 8
ID code slave 2
Byte 9
ID code slave 3
Byte 10
ID code slave 4
Byte 11
ID code slave 5
Byte 12
ID code slave 6
Byte 13
ID code slave 7
Byte 14
ID code slave 8
Byte 15
ID code slave 9
Byte 16
ID code slave 10
Byte 17
ID code slave 11
Byte 18
ID code slave 12
Byte 19
ID code slave 13
Byte 20
ID code slave 14
Byte 21
ID code slave 15
Byte 22
ID code slave 16
Byte 23
ID code slave 17
Byte 24
ID code slave 18
Bit 0
9 H
Bit 4
Bit 3
Bit 0
LAS slave 4 to 7
LAS slave 12 to 15
LAS slave 20 to 23
LAS slave 28 to 31
I/O conf. slave 0
I/O conf. slave 1
I/O conf. slave 2
I/O conf. slave 3
I/O conf. slave 4
I/O conf. slave 5
I/O conf. slave 6
I/O conf. slave 7
I/O conf. slave 8
I/O conf. slave 9
I/O conf. slave 10
I/O conf. slave 11
I/O conf. slave 12
I/O conf. slave 13
I/O conf. slave 14
I/O conf. slave 15
I/O conf. slave 16
I/O conf. slave 17
I/O conf. slave 18
4-19
AS-i Master Module CP 142-2
Advertisement
Table of Contents
