Table of Contents
Advertisement
-
Remove the printer cover (if attached).
Identify the "snap levers" as shown in Figure l-5.
Pull both snap levers forward, and at the same time . . .
Rock the tractor unit up and towards you about half an inch.
Now lift the tractor up and away from the printer.
Up to this point, we've been clearing the decks for action, so
to speak. Only two more things are left to do before we can start
printing.
They are, 1) attach the paper separator, and 2) install
the ink ribbon cartridge.
Actually, if you're planning
to print
on single sheets only, you won't need to use the paper separator,
which
are designed
expressly
to
guide
continuous
paper
(sprocket-feed)
through the printer.
-
-
-
H Attaching
the paper separator
Insert one protruding
end into the hole shown in Figure l-6
then gently bend the other protruding
end until it snaps into the
opposite hole.
_-
-
-
Paper separator
Figure
1-6. Attach
the paper separator.
-
-
6
-
Advertisement
Table of Contents
