Table of Contents
Advertisement
To remove the printer cover, lift up the free end (nearest the
center of the printer), then with a slight rocking motion, lift it
straight up and off the machine.
To replace, just reverse the
procedure.
Figure
l-2 illustrates
the proper
position
and
movement
for both removal and replacement
of the cover.
Printer Cover
.-
-
.
.
..^.
. .
Figure 1-2.
Kemove
the
pnnter cover
by
Iitting straight up.
n Removing packing and shipping screws
There are two (on an SD-lo) or three (on an SD-1.5) shipping
screws on the bottom
of the printer, used to hold the internal
chassis securely to the external frame during shipping. To get
at these, carefully place the printer upside down on a soft surface
like a foam cushion.
Remove the screws with a Phillips screw-
driver as shown in Figure l-3.
Next, remove the printer cover, and remove the spiral tube
on the carriage stay which protects the print head, per Figure
l-4.
3
Advertisement
Table of Contents
