Table of Contents
Advertisement
SAT3 Programmer: Programming Options
TO PROGRAM PHONE NUMBERS (MENU 1)
Press 1
Display will show: PHONE NUMBERS
Pick a phone number memory location from 0 - 9 and press the corresponding number key on the
keypad.
(e.g. 0 for the first phone number location.)
0 PHONE # 1
1 PHONE # 2
2 PHONE # 3
3 PHONE # 4
4 PHONE # 5
5 PHONE # 6
6 PHONE # 7
7 PHONE # 8
8 PHONE # 9
9 PHONE #10
TO PROGRAM INFO PHONE NUMBER (MENU 2)
(Second Button Phone Number; available on Special Order SAT3R/D only.)
Press 2
Display will show: INFO PHONE (See Pg 5 in the SAT3R manual.)
Key in desired Info phone number up to 16 digits.
TO PROGRAM RELAYS (MENU 3)
Press 3
Display will show: RELAY CONTROL
Select number for program function required.
1 - RLY1 TONE = 6
2 - RLY1 LATCH TONE = 0
3 - R LY1 TYPE = 0
4 - RLY2 TONE = 0
5- RLY2 LATCH TONE = 0
6 - RLY2 TYPE = 0
NOTES:
1) Key in the desired phone number, up to 16 digits.
2) When finished entering the phone number, press the "*" key to enter the num-
ber into SAT 3 memory.
3) To add additional phone numbers: Press 1, then the phone number
location (0-9) and key in the desired phone number and *.
4) If using a SAT3 product behind a PBX and an 8 or 9 plus a 3-second pause is
required to reach an outside line, press the "#" key to set a 3-second pause.
(Example: 9#3055551212)
5) There are no backspace or editing capabilities when keying in phone num-
bers. If you make an error, repeat the entire programming sequence to key the
correct phone number into the correct location.
(SAT3R only.
SATEMT Relay 2 used for Strobe Light.
SAT3R EMTWM Relay 2 used for Strobe Light.)
These are factory default settings.
For more information refer to Pg 9-11 in the-
SAT3R Manual, or your SAT3 product manual.
Pg 5
Advertisement
Table of Contents
