Table of Contents
Advertisement
SAT3 Programmer: Getting Started
A) Turn ON Power Switch.
Power-on messages should display:
SAT3 PRG VER 1.0
NO SAT CONNECTED
PROG LOCAL ONLY
(This shows that no SAT3 is connected.)
SELECT _
(If message does not show, check the battery.)
B) - Turn OFF Power Switch.
WARNING: Disconnect any and all
RJ-11 phone cables BEFORE connecting SAT3 Programmer
cabling. It MAY damage the SAT3 and WILL void the Warranty.
C) - Plug in CAT5 CABLE
(Cable should be previously connected to a SAT3 unit).
D) - Turn ON power Switch.
LCD Display should flash these lines sequentially:
SAT3 PRG VER.1.0
SES SAT3 V1.XX
(This shows the SAT3 is connected and shows revision.)
SELECT _
(If Display flashes "No Sat Connected, Prog Local Only ", turn off
power, recheck cable and turn power back on.)
E) - SAT3 is now ready to receive programming setup choices
and data from the SAT3 Programmer. We suggest you read the
Tips section on Pg 6.
Some features described in this manual may or may not, pertain
to the model SAT3 you purchased. See your SAT3 manual for
particulars on your SAT3 product.
Pg 4
Advertisement
Table of Contents
