Table of Contents
Advertisement
SAT3 Programmer: Troubleshooting
1) LCD off, No Communication:
Check SAT3 Programmer is powered on.
Check 9-volt battery is functional and reading > 7.5 volts.
Check SAT3 is NOT plugged into a phone line.
Check connectors on each end of CAT5e patch cable plugged in correctly.
2) SAT3 plugged into SAT3 Programmer - Startup displays: NO SAT CONNECTED.
Check RJ-45 cable.
Unplug RJ-45 cable, wait 10 seconds and plug back in and retry.
3) After INIT or GT or SND command, SAT3 Programmer displays: NO SAT CONNECTED.
This usually occurs from keying in a command while the SAT3 product's memory is still being pro-
grammed. To fix:
Wait 10 seconds and try next command.
Unplug RJ-45 cable, wait 10 seconds and plug back in and retry.
Power off switch, wait 10 seconds and turn power switch back on.
For all other issues, refer to the appropriate SAT3 product manual for further information.
For convenience, a Quick Guide which is a summary of the programming menu has been included.
It is on the back of the SAT3PRGRM.
The menu is slotted to permit changing the battery.
Pg 7
Advertisement
Table of Contents
