Table of Contents
Advertisement
SAT3 Programmer:
TIPS
1) Menu 9 Choice 8= GT is useful for retrieving pre-programmed data from an existing SAT3 and
storing it in the SAT3 Programmer. It will remain in that form until changed, since it is stored in non-
volatile memory.
2) Since the SAT3 Programmer stores all parameters in internal non-volatile memory, it may have
all pertinent SAT3R programming parameters "pre-programmed" prior to use in the field. It does not
have to be attached to a SAT3 product to achieve this.
The startup menu will display: PROG LOCAL ONLY to let you know you can now store SAT3 pa-
rameters in the SAT3 Programmer.
3) MENU 9 Choice 7 = SD is useful for sending the same data to more than one SAT3.
4) If sending same data to multiple SAT3's, be aware that the account numbers (if used) may need
to be changed individually, to make each SAT3's account number different.
5) If using a SAT3 product behind a PBX and an 8 or 9 plus a 3-second pause is required to reach
an outside line, press the "#" key to set a 3-second pause.
(Example: 9#3055551212)
6) If you make a mistake keying in a choice (e.g. miskeying a phone number) you can either:
A) Press * to program the (erroneous) phone number and repeat the phone sequence with the cor-
rect phone number keyed in, or
B) Turn power switch off, wait 10 seconds and turn power switch back on and repeat the desired
programming sequence.
7) To clear any and all programming entries for a SAT3 Programmer, re-initialize the memory to fac-
tory defaults by pressing 911*. This will prevent inadvertently sending erroneous data to multiple
SAT3 products.
For all other issues, refer to the appropriate SAT3 product manual for further information.
Pg 8
Advertisement
Table of Contents
