Horizontal Position Commands - Star Micronics Multi-Font NX-2410 User Manual

Select vertical tab channel
Mode 1
ASCII
Decimal
Both 1
< ESC > "i" no
I 27 47 n0
Hexadecimal
IlB 2F
n0
Selects a set of vertical tab stops designated by a channel number (no)
from 0 to 7. The tab stops in each channel are set by < ESC > "b".
Vertical tab
Mode ASCII Decimal Hexadecimal
Both 1 <VT> I 11 1 OB
Feeds the paper to the next vertical tab stop and moves the print position
to the left margin. Performs a line feed if no vertical tabs are set, as at
power-up. Feeds to the top of the next page if vertical tabs are set but
the current line is at or below the last vertical tab stop.
HORIZONTAL POSITION COMMANDS
Set left margin
IModel ASCII
I
Decimal
I
Hexadecimal 1
IBoth 1 < ESC > "1"
n
127108
n
11~ 6C
n
I
Sets the left margin at column n (where n is between 0 and 255) in the
current character pitch (pica pitch if proportional spacing is selected).
The left margin does not move if the character pitch is changed later.
The left margin must be at least two columns to the left of the right margin
and within the limits below:
Pica
Elite
Semi-condensed
Condensed pica
Condensed elite
Expanded pica
Expanded elite
Expanded semi-condensed
Expanded condensed pica
Expanded condensed elite
Set right margin
Osns76
07n791
0 <n 2 114
0 7n 7 130
0 zn < 152
O<nT38
osnT45
OZnl57
Olnl64
O&z276
Mode ASCII Decimal Hexadecimal
Std. <ESC>
"Q"
n 27 81
n
1B
51
n
IBM <FS>
"Q"
n 28 81
n
1C 51
n