Star Micronics Multi-Font NX-2410 User Manual page 81

Disable paper-out detector
Mode
ASCII
Decimal Hexadecimal
Both 1 <ESC> "8"
1 21 56
IIB 38
Causes the printer to disregard the signal sent by the paper-out detector.
enabling printing to the bottom of the paper. Overrides the setting of
DIP switch 1-5.
Enable paper-out detector
Mode ASCII
Decimal
Hexadecimal
Both I <ESC>
"9" 127 57
1 IB 39
Causes the printer to stop printing about an inch before the end of the
paper. Overrides the setting of DIP switch 1-5.
Set vertical tab stops
Mode ASCII Decimal Hexadecimal
Both I <ESC> "B" nl
n2 . ..<o
-I
4 27 66
nl n-7 . ..O 1 IB 42 nl a?...00
Cancels all current vertical tab stops and sets new vertical tab stops at
lines FII, n2, etc., where nl, n2, etc. are numbers between I and 255. A
maximum of 16 vertical tab stops can be set. The tab stops must be
specified in ascending order; any violation of ascending order terminates
the tab stop list. Standard termination is by the < 0 > control code. The
vertical tab stops are set in terms of the current line spacing and do not
move if the line spacing is changed later.
Set vertical tab stops every n lines
IModel ASCII
I
Decimal
I
Hexadecimal I
<ESC> "e" " " 1
n
27
101 49 n
lB6531
n I
Both
<ESC> "e" cl>
n 27 101 1 n
1B 65 01
n
Cancels all current vertical tab stops and sets new tab stops every n lines,
where n is between 1 and 127.
Set vertical
tab stops in channel
Mode
ASCII
Decimal
Hexadecimal
I
<ESC> "b" n0
nl 21 98 n0 nl
1B 62 n0 nl
Both
n2 . ..<O>
n2 0
n2 00
Cancels all current vertical tab stops in channel no, (where no is between
0 and 7) and sets new vertical tab stops in this channel. (A channel is a
set of vertical tab stops selected by the < ESC > "/" command.) See
< ESC > "B" for parameters nI, n2, . . . < 0 >
73